Causes and solutions of the direction deviation of the conveyor belt

Causes and solutions for the azimuth deviation of the conveyor belt:

1. Product problem: the product quality is unqualified, which leads to the unevenness of the RF connector of the data cable of the conveyor belt. Under all operating conditions, the belt conveyor is very likely to cause the two sides of the conveyor belt to be different, resulting in shaking. In order to solve this problem better and more practically, we should adjust the bearing capacity of rotation on both sides to make the unbalanced sides as stable as possible. If it is serious, we need to dismantle and replace the conveyor belt that meets the requirements.

2. Assembly difference: large and small belt conveyors have high requirements for assembly quality. If the structure tilts during installation, it will lead to significant deviation of the conveyor belt and cannot be adjusted. Therefore, in the case of assembly, try to ensure that the axes on both sides of the structure are extremely unified. In addition, the axes of available roller groups and simple centerlines are also as spatial as possible for quadrilateral belt conveyors.

3. Difficulty of blanking point: the position of blanking point will cause additional damage to the angle of conveyor belt. Belt conveyor is the key to transporting raw materials. If the blanking point is biased to one side from beginning to end, the conveyor belt will be biased. Therefore, the unloading point of raw materials should be placed in the Management Office of belt conveyor as far as possible. The feeding point of the conveyor belt has been damaged by raw materials. Under the support, the conveyor belt will be loosened, which is easy to cause the orientation deviation of the conveyor belt. Try to assemble the buffer bed to reduce the impact of raw materials, so as to reduce the stretching of the conveyor belt, resulting in deformation or aging.

4. Roller and buffer file roller adhesive: during the long-term operation of the belt conveyor, some raw materials will stick to the roller and buffer file roller, resulting in uneven conveyor belt, uneven bearing force on both sides of the conveyor belt, and deviation orientation of the conveyor belt. For this kind of thing, Changpu suggests that the coin digger be assembled or disassembled immediately, and the adhesion of raw materials be cleaned immediately, so as to ensure the stable operation of the belt conveyor.

5. Roller plastic raw materials: the quality of the rubber pad on the roller surface is weak, which is very easy to cause damage, resulting in uneven tolerance or insufficient friction resistance of some rubber pads, which is not suitable for the current transportation ecological environment protection, and it is easy to cause the orientation deviation of the conveyor belt. Changpu suggested that according to the ecological environment of the on-site engineering construction, appropriate RIT rubber pads should be selected to improve the sliding friction and avoid the deviation of the conveyor belt.